Vulnerabilities

Wasmtime is a runtime for WebAssembly. From 25.0.0 to before 36.0.7, 42.0.2, and 43.0.1, Wasmtime with its Winch (baseline) non-default compiler backend may allow properly constructed guest Wasm to access host memory outside of its linear-memory sandbox. This vulnerability requires use of the Winch compiler (-Ccompiler=winch). By default, Wasmtime uses its Cranelift backend, not Winch. With Winch, the same incorrect assumption is present in theory on both aarch64 and x86-64. The aarch64 case has an observed-working proof of concept, while the x86-64 case is theoretical and may not be reachable in practice. This Winch compiler bug can allow the Wasm guest to access memory before or after the linear-memory region, independently of whether pre- or post-guard regions are configured. The accessible range in the initial bug proof-of-concept is up to 32KiB before the start of memory, or ~4GiB after the start of memory, independently of the size of pre- or post-guard regions or the use of explicit or guard-region-based bounds checking. However, the underlying bug assumes a 32-bit memory offset stored in a 64-bit register has its upper bits cleared when it may not, and so closely related variants of the initial proof-of-concept may be able to access truly arbitrary memory in-process. This could result in a host process segmentation fault (DoS), an arbitrary data leak from the host process, or with a write, potentially an arbitrary RCE. This vulnerability is fixed in 36.0.7, 42.0.2, and 43.0.1.

V2Board 1.6.1 through 1.7.4 and Xboard through 0.1.9 expose authentication tokens in HTTP response bodies of the loginWithMailLink endpoint when the login_with_mail_link_enable feature is active. Unauthenticated attackers can POST to the loginWithMailLink endpoint with a known email address to receive the full authentication URL in the response, then exchange the token at the token2Login endpoint to obtain a valid bearer token with complete account access including admin privileges.

Wasmtime is a runtime for WebAssembly. Prior to 24.0.7, 36.0.7, 42.0.2, and 43.0.1, Wasmtime contains a possible panic which can happen when a flags-typed component model value is lifted with the Val type. If bits are set outside of the set of flags the component model specifies that these bits should be ignored but Wasmtime will panic when this value is lifted. This panic only affects wasmtime's implementation of lifting into Val, not when using the flags! macro. This additionally only affects flags-typed values which are part of a WIT interface. This has the risk of being a guest-controlled panic within the host which Wasmtime considers a DoS vector. This vulnerability is fixed in 24.0.7, 36.0.7, 42.0.2, and 43.0.1.

Wasmtime is a runtime for WebAssembly. Prior to 24.0.7, 36.0.7, 42.0.2, and 43.0.1, On x86-64 platforms with SSE3 disabled Wasmtime's compilation of the f64x2.splat WebAssembly instruction with Cranelift may load 8 more bytes than is necessary. When signals-based-traps are disabled this can result in a uncaught segfault due to loading from unmapped guard pages. With guard pages disabled it's possible for out-of-sandbox data to be loaded, but this data is not visible to WebAssembly guests. This vulnerability is fixed in 24.0.7, 36.0.7, 42.0.2, and 43.0.1.

Wasmtime is a runtime for WebAssembly. From 25.0.0 to before 36.0.7, 42.0.2, and 43.0.1, Wasmtime's Winch compiler contains a bug where a 64-bit table, part of the memory64 proposal of WebAssembly, incorrectly translated the table.size instruction. This bug could lead to disclosing data on the host's stack to WebAssembly guests. The host's stack can possibly contain sensitive data related to other host-originating operations which is not intended to be disclosed to guests. This bug specifically arose from a mistake where the return value of table.size was statically typed as a 32-bit integer, as opposed to consulting the table's index type to see how large the returned register could be. When combined with details about Wnich's ABI, such as multi-value returns, this can be combined to read stack data from the host, within a guest. This vulnerability is fixed in 36.0.7, 42.0.2, and 43.0.1.

Wasmtime is a runtime for WebAssembly. From 25.0.0 to before 36.0.7, 42.0.2, and 43.0.1, Wasmtime's Winch compiler contains a vulnerability where the compilation of the table.fill instruction can result in a host panic. This means that a valid guest can be compiled with Winch, on any architecture, and cause the host to panic. This represents a denial-of-service vulnerability in Wasmtime due to guests being able to trigger a panic. The specific issue is that a historical refactoring changed how compiled code referenced tables within the table.* instructions. This refactoring forgot to update the Winch code paths associated as well, meaning that Winch was using the wrong indexing scheme. Due to the feature support of Winch the only problem that can result is tables being mixed up or nonexistent tables being used, meaning that the guest is limited to panicking the host (using a nonexistent table), or executing spec-incorrect behavior and modifying the wrong table. This vulnerability is fixed in 36.0.7, 42.0.2, and 43.0.1.

Wasmtime is a runtime for WebAssembly. From 32.0.0 to before 36.0.7, 42.0.2, and 43.0.1, Wasmtime's Cranelift compilation backend contains a bug on aarch64 when performing a certain shape of heap accesses which means that the wrong address is accessed. When combined with explicit bounds checks a guest WebAssembly module this can create a situation where there are two diverging computations for the same address: one for the address to bounds-check and one for the address to load. This difference in address being operated on means that a guest module can pass a bounds check but then load a different address. Combined together this enables an arbitrary read/write primitive for guest WebAssembly when accesssing host memory. This is a sandbox escape as guests are able to read/write arbitrary host memory. This vulnerability has a few ingredients, all of which must be met, for this situation to occur and bypass the sandbox restrictions. This miscompiled shape of load only occurs on 64-bit WebAssembly linear memories, or when Config::wasm_memory64 is enabled. 32-bit WebAssembly is not affected. Spectre mitigations or signals-based-traps must be disabled. When spectre mitigations are enabled then the offending shape of load is not generated. When signals-based-traps are disabled then spectre mitigations are also automatically disabled. The specific bug in Cranelift is a miscompile of a load of the shape load(iadd(base, ishl(index, amt))) where amt is a constant. The amt value is masked incorrectly to test if it's a certain value, and this incorrect mask means that Cranelift can pattern-match this lowering rule during instruction selection erroneously, diverging from WebAssembly's and Cranelift's semantics. This incorrect lowering would, for example, load an address much further away than intended as the correct address's computation would have wrapped around to a smaller value insetad. This vulnerability is fixed in 36.0.7, 42.0.2, and 43.0.1.

Wasmtime is a runtime for WebAssembly. In 43.0.0, cloning a wasmtime::Linker is unsound and can result in use-after-free bugs. This bug is not controllable by guest Wasm programs. It can only be triggered by a specific sequence of embedder API calls made by the host. Specifically, the following steps must occur to trigger the bug clone a wasmtime::Linker, drop the original linker instance, use the new, cloned linker instance, resulting in a use-after-free. This vulnerability is fixed in 43.0.1.

An issue was discovered in ToToLink A3300R firmware v17.0.0cu.557_B20221024 allowing attackers to execute arbitrary commands via the stun-pass parameter to /cgi-bin/cstecgi.cgi.

OpenPLC_V3 is vulnerable to an Initialization of a Resource with an Insecure Default vulnerability which could allow an attacker to gain access to the system by bypassing authentication via an API.

Wasmtime is a runtime for WebAssembly. Prior to 24.0.7, 36.0.7, 42.0.2, and 43.0.1, Wasmtime contains a vulnerability where when transcoding a UTF-16 string to the latin1+utf16 component-model encoding it would incorrectly validate the byte length of the input string when performing a bounds check. Specifically the number of code units were checked instead of the byte length, which is twice the size of the code units. This vulnerability can cause the host to read beyond the end of a WebAssembly's linear memory in an attempt to transcode nonexistent bytes. In Wasmtime's default configuration this will read unmapped memory on a guard page, terminating the process with a segfault. Wasmtime can be configured, however, without guard pages which would mean that host memory beyond the end of linear memory may be read and interpreted as UTF-16. A host segfault is a denial-of-service vulnerability in Wasmtime, and possibly being able to read beyond the end of linear memory is additionally a vulnerability. Note that reading beyond the end of linear memory requires nonstandard configuration of Wasmtime, specifically with guard pages disabled. This vulnerability is fixed in 24.0.7, 36.0.7, 42.0.2, and 43.0.1.

Wasmtime is a runtime for WebAssembly. Prior to 24.0.7, 36.0.7, 42.0.2, and 43.0.1, Wasmtime's implementation of transcoding strings into the Component Model's utf16 or latin1+utf16 encodings improperly verified the alignment of reallocated strings. This meant that unaligned pointers could be passed to the host for transcoding which would trigger a host panic. This panic is possible to trigger from malicious guests which transfer very specific strings across components with specific addresses. Host panics are considered a DoS vector in Wasmtime as the panic conditions are controlled by the guest in this situation. This vulnerability is fixed in 24.0.7, 36.0.7, 42.0.2, and 43.0.1.