Vulnerabilities

Information disclosure issue occurs as there is no binding between the secure keypad session and the secure display session that allows user to take control of the REE to stop the secure keypad session and read the keypad input. in Snapdragon Auto, Snapdragon Compute, Snapdragon Connectivity, Snapdragon Consumer IOT, Snapdragon Industrial IOT, Snapdragon Mobile, Snapdragon Voice & Music, Snapdragon Wired Infrastructure and Networking in APQ8009, MSM8905, MSM8909

Side channel issue in QTEE due to usage of non-time-constant comparison function such as memcmp or strcmp in Snapdragon Auto, Snapdragon Compute, Snapdragon Connectivity, Snapdragon Consumer Electronics Connectivity, Snapdragon Consumer IOT, Snapdragon Industrial IOT, Snapdragon IoT, Snapdragon Mobile, Snapdragon Voice & Music, Snapdragon Wearables, Snapdragon Wired Infrastructure and Networking in APQ8009, APQ8016, APQ8017, APQ8053, APQ8076, APQ8096, APQ8096AU, APQ8098, IPQ8074, MDM9150, MDM9205, MDM9206, MDM9207C, MDM9607, MDM9640, MDM9650, MDM9655, MSM8905, MSM8909, MSM8909W, MSM8917, MSM8920, MSM8937, MSM8940, MSM8953, MSM8996, MSM8996AU, MSM8998, QCA8081, QCS404, QCS605, QM215, SDA660, SDA845, SDM429, SDM439, SDM450, SDM630, SDM632, SDM636, SDM660, SDM670, SDM710, SDM845, SDM850, SDX20, SDX55, SM6150, SM7150, SM8150, SXR1130, SXR2130

When issuing IOCTL calls to ION, Memory leak can occur due to failure in unassign pages under certain conditions in Snapdragon Auto, Snapdragon Compute, Snapdragon Consumer Electronics Connectivity, Snapdragon Consumer IOT, Snapdragon Industrial IOT, Snapdragon Mobile, Snapdragon Voice & Music, Snapdragon Wearables, Snapdragon Wired Infrastructure and Networking in APQ8009, APQ8053, APQ8096AU, APQ8098, IPQ8074, MDM9206, MDM9207C, MDM9607, MDM9640, MDM9650, MSM8909W, MSM8953, MSM8996AU, Nicobar, QCN7605, QCS605, Rennell, Saipan, SC8180X, SDA660, SDA845, SDM429, SDM429W, SDM439, SDM450, SDM632, SDM710, SDX24, SDX55, SM7150, SM8150, SM8250, SXR2130

Target specific data is being sent to remote server and leads to information exposure in Snapdragon Auto, Snapdragon Compute, Snapdragon Consumer IOT, Snapdragon Industrial IOT, Snapdragon IoT, Snapdragon Mobile, Snapdragon Wearables in APQ8009, APQ8053, APQ8096AU, MSM8909W, MSM8917, MSM8920, MSM8937, MSM8940, MSM8953, MSM8996AU, QCA6574AU, QCS605, Rennell, SDA660, SDM429W, SDM439, SDM450, SDM710, SDM845, SM7150, SM8150, SM8250, SXR2130

A vulnerability in the web-based management interface of Cisco Mobility Express Software could allow an unauthenticated, remote attacker to conduct a cross-site request forgery (CSRF) attack on an affected system. The vulnerability is due to insufficient CSRF protections for the web-based management interface on an affected device. An attacker could exploit this vulnerability by persuading a user with an active session on an affected device to follow a malicious link. A successful exploit could allow the attacker to perform arbitrary actions, including modifying the configuration, with the privilege level of the user.

Rejected reason: DO NOT USE THIS CANDIDATE NUMBER. ConsultIDs: none. Reason: This candidate was withdrawn by its CNA. Further investigation showed that it was not a security issue. Notes: none

MikroTik WinBox 3.22 and below stores the user's cleartext password in the settings.cfg.viw configuration file when the Keep Password field is set and no Master Password is set. Keep Password is set by default and, by default Master Password is not set. An attacker with access to the configuration file can extract a username and password to gain access to the router.

A vulnerability in the 802.11 Generic Advertisement Service (GAS) frame processing function of Cisco Wireless LAN Controller (WLC) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS). The vulnerability is due to incomplete input validation of the 802.11 GAS frames that are processed by an affected device. An attacker could exploit this vulnerability by sending a crafted 802.11 GAS frame over the air to an access point (AP), and that frame would then be relayed to the affected WLC. Also, an attacker with Layer 3 connectivity to the WLC could exploit this vulnerability by sending a malicious 802.11 GAS payload in a Control and Provisioning of Wireless Access Points (CAPWAP) packet to the device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS.

In SilverStripe through 4.5, files uploaded via Forms to folders migrated from Silverstripe CMS 3.x may be put to the default "/Uploads" folder instead. This affects installations which allowed upload folder protection via the optional silverstripe/secureassets module under 3.x. This module is installed and enabled by default on the Common Web Platform (CWP). The vulnerability only affects files uploaded after an upgrade to 4.x.

A vulnerability in the Control and Provisioning of Wireless Access Points (CAPWAP) protocol handler of Cisco Wireless LAN Controller (WLC) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to insufficient validation of CAPWAP packets. An attacker could exploit this vulnerability by sending a malformed CAPWAP packet to an affected device. A successful exploit could allow the attacker to cause the affected device to restart, resulting in a DoS condition.

In a certain condition, receipt of a specific BGP UPDATE message might cause Juniper Networks Junos OS and Junos OS Evolved devices to advertise an invalid BGP UPDATE message to other peers, causing the other peers to terminate the established BGP session, creating a Denial of Service (DoS) condition. For example, Router A sends a specific BGP UPDATE to Router B, causing Router B to send an invalid BGP UPDATE message to Router C, resulting in termination of the BGP session between Router B and Router C. This issue might occur when there is at least a single BGP session established on the device that does not support 4 Byte AS extension (RFC 4893). Repeated receipt of the same BGP UPDATE can result in an extended DoS condition. This issue affects Juniper Networks Junos OS: 16.1 versions prior to 16.1R7-S6; 16.2 versions prior to 16.2R2-S11; 17.1 versions prior to 17.1R2-S11, 17.1R3-S2; 17.2 versions prior to 17.2R1-S9, 17.2R2-S8, 17.2R3-S3; 17.2X75 versions prior to 17.2X75-D105, 17.2X75-D110, 17.2X75-D44; 17.3 versions prior to 17.3R2-S5, 17.3R3-S7; 17.4 versions prior to 17.4R2-S8, 17.4R3; 18.1 versions prior to 18.1R3-S8; 18.2 versions prior to 18.2R2-S6, 18.2R3-S2; 18.2X75 versions prior to 18.2X75-D12, 18.2X75-D33, 18.2X75-D411, 18.2X75-D420, 18.2X75-D51, 18.2X75-D60; 18.3 versions prior to 18.3R1-S6, 18.3R2-S3, 18.3R3; 18.4 versions prior to 18.4R1-S5, 18.4R3; 18.4 version 18.4R2 and later versions; 19.1 versions prior to 19.1R1-S3, 19.1R2; 19.2 versions prior to 19.2R1-S2, 19.2R2. This issue does not affect Juniper Networks Junos OS prior to 16.1R1. This issue affects Juniper Networks Junos OS Evolved prior to 19.2R2-EVO.

Multiple vulnerabilities in the REST API of Cisco UCS Director and Cisco UCS Director Express for Big Data may allow a remote attacker to bypass authentication or conduct directory traversal attacks on an affected device. For more information about these vulnerabilities, see the Details section of this advisory.