Vulnerabilities

The MCTP-over-I2C+GPIO target binding in Zephyr (subsys/pmci/mctp/mctp_i2c_gpio_target.c) processes pseudo-register writes from an I2C bus master byte-by-byte in mctp_i2c_gpio_target_write_received() without validating the order or the receive buffer. In the affected versions the MCTP_I2C_GPIO_RX_MSG_ADDR (data) handler dereferences and writes through b-&gt;rx_pkt without checking that the receive buffer was allocated: a controller that selects the data register and writes a byte without first sending the length register (which is what allocates the buffer) causes a write of an attacker-chosen byte through a NULL/unallocated mctp_pktbuf pointer (i.e. into a small attacker-advanceable offset above address 0), producing memory corruption or a hard fault.<br /> <br /> The same handler also performs a write-then-check bounds test, allowing a one-byte heap overflow at data[255] when more than 255 data bytes are sent.<br /> <br /> Because the I2C target callback is invoked with raw bytes supplied by whatever device is the bus master and the binding performs no authentication, a malicious or malfunctioning controller on the bus can trigger these without any prior protocol state, leading to memory corruption and/or denial of service on the target device.<br /> <br /> The vulnerable code was introduced when the I2C+GPIO target binding was added and shipped in Zephyr v4.3.0 and v4.4.0. The fix defers allocation to the first data byte with a NULL check, treats a missing length as a zero-sized packet rejected by libmctp, and moves the bounds check before the store.

The CONFIG_USERSPACE syscall verifier z_vrfy_k_poll() in kernel/poll.c allocates a kernel-side copy of the user-supplied k_poll_event[] via z_thread_malloc() and then validates each event&amp;#39;s object handle. Before this fix, validation used K_OOPS(K_SYSCALL_OBJ(...)) inline inside the loop, which kills the calling thread without freeing events_copy.<br /> <br /> A user thread can pass num_events &gt;= 1 with a forged object handle to leak the allocation; because newly spawned user threads inherit the parent&amp;#39;s resource_pool (kernel/thread.c), an attacker spawns sacrificial threads to repeat the leak until the shared kernel heap is exhausted. Once depleted, legitimate kernel allocations from that pool (k_queue alloc nodes, k_msgq buffers, future k_poll calls, etc.) fail, causing a system-level denial of service.<br /> <br /> The fix replaces each inline K_OOPS with a conditional goto oops_free so the buffer is freed before the thread is killed. Affects Zephyr releases from v1.12.0 (when k_poll was first exposed to user mode) through v4.4.1.

In Zephyr&amp;#39;s Bluetooth Mesh PB-ADV provisioning bearer (subsys/bluetooth/mesh/pb_adv.c), prov_msg_recv() rescheduled the provisioning protocol watchdog timer unconditionally at the top of the function, before the FCS check and before the ADV_LINK_INVALID check. Once a provisioning attempt fails, prov_failed() sets ADV_LINK_INVALID and the only recovery path is the protocol timer firing (protocol_timeout -&gt; prov_link_close -&gt; close_link -&gt; reset_adv_link and re-enabling of scanning and the unprovisioned device beacon).<br /> <br /> A remote, unauthenticated attacker on the BLE advertising channel can first induce a provisioning failure (e.g. with a malformed generic-provisioning PDU) and then transmit any FCS-valid PB-ADV transaction PDU on the same link ID more often than once per protocol timeout (60 s, or 120 s for OOB input/output). Because each such packet reset the timer even on an invalidated link, protocol_timeout never fired, the dead link was never torn down, and the device remained pinned in an un-provisionable state with its unprovisioned beacon disabled and new Link Open requests rejected.<br /> <br /> PB-ADV PDUs are processed without authentication and the FCS is a keyless CRC, so no pairing or prior trust is required and the attacker chooses the link ID itself. The impact is a persistent denial of provisioning/re-provisioning service; there is no memory-safety, confidentiality, or integrity impact.<br /> <br /> The vulnerable code shipped in releases through v4.4.1. The fix moves the timer reschedule to after the ADV_LINK_INVALID check (and the FCS check before the reset) so an invalidated link can no longer be kept alive by incoming packets.

The NXP LPUART serial driver (drivers/serial/uart_mcux_lpuart.c), when CONFIG_UART_USE_RUNTIME_CONFIGURE is enabled, called LPUART_Deinit() at the start of mcux_lpuart_configure(), which disables the LPUART peripheral clocks. The requested configuration is validated only afterwards (in mcux_lpuart_configure_basic), and unsupported parity/data-bit/stop-bit/flow-control values return -ENOTSUP before the clock is re-enabled.<br /> <br /> As a result, a uart_configure() request with an unsupported configuration left the LPUART in a clock-disabled state; any subsequent access to LPUART registers (poll_out/poll_in, interrupt handling, or a later reconfigure) faults on the gated peripheral and escalates to a hard fault, crashing the system.<br /> <br /> uart_configure() is a Zephyr syscall whose verifier (z_vrfy_uart_configure) only checks that cfg is readable user memory and forwards the caller-supplied configuration unchanged, so an unprivileged userspace thread with access to an LPUART device can deterministically trigger the fault, a persistent system-wide denial of service.<br /> <br /> Introduced in v2.5.0 and present in all subsequent releases until this fix, which removes the LPUART_Deinit() call and instead only disables the transmitter/receiver, leaving the clock running.

Two undocumented privileged accounts exist in Autel Maxi Charger Single firmware through V1.03.51. The accounts use vendor-defined password derivation mechanisms based on device-specific values, allowing an attacker with knowledge of the algorithm and required inputs to authenticate to the web management interface with administrative privileges.

Autel Maxi Charger Single firmware through V1.03.51 contains a hard-coded authentication token that bypasses authorization checks for multiple management endpoints. An attacker can supply the special token value to invoke privileged functionality without valid authentication.

MediaCMS 8.2.0 contains an information disclosure vulnerability that allows authenticated users to expose private media metadata belonging to other users by adding arbitrary media tokens to their own playlist without access control checks. Attackers can issue a PUT request to the playlist API endpoint with a known media token to bypass state and ownership validation, then retrieve the playlist to read private media fields including title, description, view count, like count, file size, author username, and encoding status through the unfiltered playlist owner branch in the playlist detail view.

Keep (commit 91c75e0) contains a server-side request forgery vulnerability that allows unauthenticated attackers to make the backend issue arbitrary HTTP requests by supplying attacker-controlled host values to the unprotected healthcheck endpoint. Attackers can send a crafted JSON payload with a malicious host parameter to cause the backend to issue outbound requests to internal services or cloud metadata endpoints, enabling theft of cloud credentials and internal network reconnaissance.

Taiga 6.10.1 contains a missing authorization vulnerability that allows unauthenticated attackers to disclose the full member roster and internal workflow configuration of any private project by supplying a project ID to the filters_data API endpoints on UserStory, Task, Issue, and Epic viewsets. Attackers can send unauthenticated GET requests to the filters_data endpoints with sequential integer project IDs to enumerate private project membership details including user IDs, full names, and gravatar hashes, bypassing the access controls that correctly restrict other project API endpoints.

mcp-webresearch 0.1.7 contains a server-side request forgery vulnerability that allows attackers to access internal network services by supplying loopback, link-local, or cloud metadata addresses to the visit_page tool, which only validates the URL protocol without filtering private or reserved IP ranges. Attackers can steer the LLM-controlled URL argument through prompt injection to navigate the server&amp;#39;s Playwright browser to internal endpoints such as cloud instance metadata services, causing the server to return sensitive internal page content including credentials into the model context.

Trezor Safe 3, Safe 5, and Safe 7 firmware contains a confirmation-binding flaw in the Ethereum sign_tx / sign_tx_eip1559 flow. For contract interactions, the device confirms only the initial calldata chunk while the signature commits to the full streamed calldata. An attacker could present calldata to a victim then supply a different tail that changes the signed transaction. Fixed in 70c9b0c.

Reachable Assertion (CWE-617) in Elasticsearch can lead to denial of service via Input Data Manipulation (CAPEC-153). A specially crafted search request containing a null value in a specific query clause causes an internal assertion to be raised during query parsing. Because Elasticsearch treats assertion failures as fatal errors, this terminates the affected node process. A low-privileged authenticated user with read access to at least one index can exploit this condition with a single request to cause a node to terminate, disrupting search availability. In a single-node deployment this fully stops Elasticsearch; in a multi-node cluster it reduces cluster capacity for each affected node.